Device Recall Emax Consoles

  • 모델명 / 제조번호(시리얼번호)
    SC2100 System Console Emax 2 Plus; SC2101 System Console, Single Port with irrigation; SC2102 System Console, Single Port, without Irrigation;
  • 의료기기 분류등급
  • 의료기기 등급
    HDE
  • 이식된 장치?
    Yes
  • 유통
    Worldwide Distribution - USA Nationwide including the states of: AZ, CA, FL, KY, ME, MI, MO, OH, PA, TN, TX , VA, and the countries of: Australia, Egypt, Italy, Japan, Switzerland, Taiwan, and Turkey;
  • 제품 설명
    ***REF SC2102***eMax 2 Plus Console, Single Port, no Irrigation***SN G16307882402*** || Product Usage: || The eMax console is intended to operate the eMax system which is used for cutting and shaping bone including spine and cranium. The RPM of the Motor Handpiece may be less than 80,000 RPM (approximately 72,000 RPM) in the free running state when using the optional Hand Control. The low Motor Handpiece RPM would only be experienced in the Free running state (Hand Control fully depressed and no load on the cutting bur). This condition would not affect the power output of the Handpiece in the loaded working range (typically 50,000 to 70,000 RPM).
  • Manufacturer
  • 2 Events

제조사

  • 제조사 주소
    The Anspach Effort, Inc., 4500 Riverside Drive, Palm Beach Gardens FL 33410-4235
  • 제조사 모회사 (2017)
  • Source
    USFDA

유사한 이름을 가진 의료기기 1건 유사한 이름을 가진 의료기기 1 건

데이터에 대해 더 자세히 알아보기 여기

  • 모델명 / 제조번호(시리얼번호)
    SC2100 System Console Emax 2 Plus; SC2101 System Console, Single Port with irrigation; SC2102 System Console, Single Port, without Irrigation.
  • 의료기기 분류등급
  • 의료기기 등급
    HDE
  • 이식된 장치?
    Yes
  • 유통
    Worldwide Distribution - USA Nationwide including the states of: AZ, CA, FL, KY, ME, MI, MO, OH, PA, TN, TX , VA, and the countries of: Australia, Egypt, Italy, Japan, Switzerland, Taiwan, and Turkey;
  • 제품 설명
    ***REF SC2100***eMax 2 Plus Console***SN G 10307653002*** || Product Usage: || The RPM of the Motor Handpiece may be less than 80,000 RPM (approximately 72,000 RPM) in the free running state when using the optional Hand Control. The low Motor Handpiece RPM would only be experienced in the Free running state (Hand Control fully depressed and no load on the cutting bur). This condition would not affect the power output of the Handpiece in the loaded working range (typically 50,000 to 70,000 RPM.
  • Manufacturer