Drager Infinity Acute Care System (IACS) Monitoring Solution with software versions VG2.2 to VG6.0 and the Infinity M540 Stand-Alone Patient Monitor with software versions from VG2.2 to VG6.0 의 리콜

Recall

RC-2018-RN-00154-1

Class I

2018-03-13

Australia

DHTGA

https://apps.tga.gov.au/Prod/sara/arn-detail.aspx?k=RC-2018-RN-00154-1

Drager has determined that when the infinity m540 patient monitor is placed in standby mode and the user simultaneously connects the infinity mcable- dual hemo or infinity mpod quad-hemo to the infinity m540 patient monitor and then proceeds to zero the invasive pressure channel, in rare cases the invasive pressure visual and audible alarms are not activated. although the invasive pressure value displayed on the infinity m540 patient monitor and on the infinity medical cockpit is accurate, the invasive pressure visual and audible alarms will stay disabled until the patient is discharged or the hemodynamic pod is disconnected and reconnected.This issue is not seen when the user puts the m540 into stand-by mode, and then connects the hemodynamic pod in a sequential manner. the actual ibp measurements, and the patient values are correctly displayed on both the m540 and cockpit at all times.

Drager is advising users to follow the below identified steps whenever the Hemodynamic Pod is plugged into the Infinity M540 Patient Monitor and the unit is placed in Standby. When users are ready to monitor the patient: 1. Exit Standby Mode 2. Unplug, pause for a minimum of 3 seconds and re-plug the Hemodynamic Pod 3. Continue per the normal procedure. Drager will be performing a software update as a permanent correction.