Shimadzu Ceiling Type X-ray Tube Support 의 리콜

Recall

RC-2017-RN-00698-1

Class II

2017-06-08

Australia

DHTGA

https://apps.tga.gov.au/Prod/sara/arn-detail.aspx?k=RC-2017-RN-00698-1

The x-ray tube assembly in these devices is mounted to a tube mounting flange, which is part of the tube holding shaft. it was found that, extremely infrequently, a crack may occur over time on the tube holding shaft near the base of the tube mounting flange. if these cracks occur and then increase in size, the tube mounting flange may separate from the tube holding shaft. should separation of the tube mounting flange from the tube holding shaft occur, there is a risk that the x-ray tube assembly may come into contact with the patient or operator.

Shimadzu will be contacting users to arrange for installation of additional protection parts to the x-ray tube support by a Shimadzu technical support engineer, to prevent the x-ray tube assembly from coming into contact with the patient or operator should separation of the tube mounting flange from the tube holding shaft occur. In the interim, users are advised to take the following actions: - Carry out daily inspection of the CH-200/CH-200 M as per instruction manual. - If abnormalities are found, such as rattling and/or deviation of the light irradiation field, discontinue use and contact the service representative. - When rotating the X-ray tube device, control the movement of the X-ray tube assembly to avoid a forceful stop at the end of the rotational movement. In the unlikely event that cracks have already occurred, a forceful stop at the end of rotational movement may accelerate cracking.